Institut für Transport- und Automatisierungstechnik Forschung Publikationen
Influence of an oxygen-free atmosphere on laser beam brazing of aluminium with prior surface deoxidation by pulsed laser radiation

Individualized and controlled laser beam pretreatment process for adhesive bonding of fiber-reinforced plastics. II. Automatic laser process control by spectrometry

Kategorien Zeitschriften/Aufsätze (reviewed)
Jahr 2021
Autoren Dittmar, H.; Weiland, J.; Wippo, V.; Schiebahn, A.; Jaeschke, P.; Kaierle, S.; Reisgen, U.; Overmeyer, L.
Veröffentlicht in Journal of Laser Applications 33, 012004
Beschreibung

This paper describes the research conducted on the automation for a UV laser-based surface pretreatment of fiber-reinforced composites in order to improve adhesive bonding conditions. In a preceding process step, a laser-line-triangulation system gathered inline information on a composite part’s surface like topology and location of surface contaminants. These data are the basis for an automation of the laser-based surface treatment [J. Weiland, B. Kunze, H. Dittmar, B. Marx, A. Schiebahn, P. Jaeschke, L. Overmeyer, and U. Reisgen, Proc. Inst. Mech. Eng. Part E: J. Process Mech. Eng. 234, 1–10 (2020)]. The gathered data describe the position of bonding areas and surface contaminants and are converted into relative coordinates of the laser’s scanning field. During the following laser process, the bonding area is ablated to improve adhesive bonding conditions. The process is monitored online by a broad bandwidth spectrometer covering the range of λ = 200–1100 nm to detect changes in the surface composition. If the spectrometer detects signals related to specific surface contaminants during the laser process, the position of the contamination is logged. In this case, only the areas that showed traces of surface contaminations are laser treated again until the spectrometer stops detecting the contaminant signature. This work presents results of two series of experiments. During the first series of experiments, the spectrometer monitored a UV laser process on a carbon fiber reinforced epoxy. The laser processing was performed on a clean and contaminated surface. An industry standard release agent contaminated the plastic surface. The spectrometer detected differences between the clean and contaminated surface that will be used for an automatic process control. In a second series of experiments, the authors performed a processing parameter analysis in order to identify a potential process window for laser-based surface pretreatment for glass-fiber reinforced polyamide 6. Contact angle analysis, surface roughness measurements, peel strength, and shear strength tests were performed. The results show that an inline controlled laser process is robustly able to pretreat composite surfaces based on spectrometric measurements.

DOI 10.2351/7.0000301